3D printing troubleshooting

• Maintinence
• General solution guide built into community site
• Important things to note about our 3D printers
• Filaments that causes damage

Maintinence

General solution guide built into community site

Specifically meant to calibrate 3D printers. 

Also includes a cause-solution guidance throughout

https://teachingtechyt.github.io/calibration.html

Important things to note about our 3D printers

we did a board swap on the ender 3 max: SKR mini e3 V2 

This also is a board that CANNOT accept firmware flashes over USB due to the hardware. It must be done by the SD card slot on it. 

Filaments that causes damage

PLA

 

ASA

 

PETG

DO NOT PRINT ON GLASS

Heated glass beds fuse with petg